Magnescale SR-801 Bedienungsanleitung Seite 33

5
SR-801
Mount the head connector (Canon type) near the head carrier. (Remove the connector cover
once and after mounting attach it to the connector.) Drill an M4 × 5 hole alignment with the
connector mount hole and secure the connector with 2 ea M4 × 6 screws. For location of the
connector mount holes, refer to the outline drawing.
SR-801R
Choose the position to attach the connector receptacle for connecting the head cable close to
the head carrier. Attach in numerical order.
Note
Secure the head cable and conduit cable with cable clamps so that they do not get in the way
of the machine's movement.
w Secure the conduit cable with two M4 × 16 screws. (suppried)
Connector receptacle
e Insert the connector plug.
t Wire clamp (small)
M4 × 12 screw (suppried)
Head cable
r Secure the head cable with two M3 × 25 screws. (suppried)
2-M4 × 6
Loosen 2 ea M2.6 screws
Remove
M4, 5 depth
Connector cover
Conduit cable
q Drill and tap M4 holes (two places) 5/0.19" deep.
t Wire clamp held in place (big)
M4 × 12 screw (suppried)
31