Mounting And Adjustment - Magnescale SR-801 Bedienungsanleitung

3-5. Mounting and adjustment

Items required for mounting and adjustment: SR-801,SR-801R
Mounting screws
(hexagon socket)
Knock-pins
Gauge-pins
Spacers
"L" wrench
Phillips screwdriver
Electric drill
Spring washer
Flat washer
Round head screw
Clamper
Flat washer
• After determining the mounting position and location of the scale and carrier, drill an M6 × 15
M6 × 15
Face C
• Prior to mounting the scale, ensure that scale mounting faces A and B and head mounting face
Contents
M6 × 14 (for mounting head carrier and scale)
M4 × 6 (for mounting the connector)
M4 × 16 (for mounting the connector reseptacle)
ø5 × 12 (for mounting head carrier and scale)
ø5 × 45 (for positioning jig block)
t = 0.1/0.004", 0.5/0.020", 0.6/0.024", 0.8/0.031",
1.0/0.039", 1.2/0.047", 1.4/0.055" (mm/inch)
for M6 screws (opposite side 5)
for M4 screws (opposite side 3)
for drilling holes for the knock-pins (ø5)
M6 (for head carrier screw)
M6 (for head carrier screw)
M3 × 25 (for mounting connector plug)
M4 × 12 (for clamper)
large (for mounting conduit cable)
small (for mounting head cable)
M4 (for large clamper)
pilot hole at each mount hole location as indicated on the outline drawing.
Face B
C have no irregularities exceeding the limits specified below.
Faces A and B
Face C
Distance between face B and face C
Parallelism of face B and face C
Face A
Scale effective length
M6 × 15
2000/78.7" to 3000/118.1" mm
: within 0.1 mm/0.004"
: within 0.05 mm/0.002"
: 25.5±0.2 mm/1.004"±0.008"
: within 0.05 mm/0.002"
SR-801 SR-801R
14 (suppried) 14 (suppried)
2 (suppried) —————
————— 2 (suppried)
6 (suppried) 6 (suppried)
1 (suppried) 1 (suppried)
total 7 (suppried)
total 7 (suppried)
1 1
1 1
1 1
1 1
2 (suppried) 2 (suppried)
2 (suppried) 2 (suppried)
—————
2 (suppried)
————— 5 (suppried)
————— 3 (suppried)
————— 1 (suppried)
————— 3 (suppried)
Total number of M6
pilot holes
14
29