IFM Electronic efector300 SA3010 Bedienungsanleitung Seite 26

Technical information / Functioning / Parameters
Calibration reset
- Press the "Mode/Enter" button until CAr is displayed.
- Press the "Set" button and keep it pressed until "- - -" is displayed.
- Then press the "Mode/Enter" button briefly.
The calibration set by CGA is reset; the calibration indicator no longer lights.
Start-up delay
During this time special conditions apply to the switching of the outputs
→
(Explanation page 29)
• adjustable in steps of 1s.
• setting range: 0 ... 50s (0 = start-up delay not active).
The time applies to both outputs.
Output palarity
2 options can be selected:
- PnP = positive switching
- nPn = negative switching
This setting applies to both switching outputs
Setting of the display
3 options can be selected:
• d3 = normal display
• rd3 = display rotated 180°
• OFF = The display is deactivated in the Run mode.
When one of the buttons is pressed the current measured value is displayed for 15s.
When the Mode/Enter button is then pressed, the display mode is opened.
The LEDs indicating the switching state and the calibration indicator remain active even if
the display is deactivated.
Display unit
5 options can be selected:
• Lit = litre / min.
• GAL = gallons/min.
• LPH = litre / hour
• GPH = gallons /hour
• CPH = cubic metre /hour
For nominal diameter 19 and 24, 1/10 of the LPH value is displayed.
The displayed value must be multiplied by factor 10.
Example: displayed value = 98; real value = 98 * 10 = 980 LPH
Labels for the different units of display are enclosed with the unit. Stick the respective
label on the sensor or fill in the blank label.
Select the display unit before setting the switch points (SPx, rPx) or the limits for the
analog output signal (ASP, AEP). This avoids rounding errors generated internally during
the conversion of the units and enables exact setting of the values.
Page 26