Engine Oil - Stiga JB 350 Gebrauchsanweisung

EN
• Always make sure you have a good footing,
especially on slopes.
• Check that no one is in front of you or beside
you when starting the blades. Keep a steady
grip on the steering. The machine will lift when
the rotors are started. Use extra caution when
backing.
• Always keep at a safe distance to the rotors
when working.
• Holding the steering correctly ensures a safe
distance.
• No person must come closer than 20 m to the
machine when working on slopes. The user
must hold the steering firmly with both hands
all the time.
• Working on stony or hard ground demands
extra attention from the operator. The machine
becomes more unstable.
• Never touch the engine when operating the
machine, or just afterwards. Risk for burn
injuries.
2.4 AFTER OPERATING
• Allow the engine to cool before putting the
machine in a storeroom. Fire risk!
• Remove dirt and foreign material before putting
the machine in a storeroom. The area round the
petrol tank and muffler must be kept clean from
leaves, oil, petrol or other foreign materials.
Fire risk!
• If the petrol tank is to be emptied, do this
outdoors and when the engine is cold. Fire risk!
• The machine should be stored in a dry place.
The machine must not stored with fuel in the
tank in rooms where there are naked flames,
sparks or other strong sources of heat.
2.5 MAINTENANCE
• Carry out maintenance regularly. All nuts and
bolts should always be tight.
• Only use genuine spare parts which are in good
condition. Spare parts must not be repaired.
They must be replaced if they are defective.
Poor quality spare parts can lead to personal
injury. If the muffler is damaged it must be
replaced.
• The engine must be stopped and the spark plug
lead disconnected in the following
circumstances:
When adjusting the rotors.
When the machine is to be cleaned or repaired.
When checking after a collision with a solid
hard object. Carry out the necessary repairs be-
fore continuing to work.
30
ENGLISH
If the machine begins to vibrate abnormally.
Carry out the necessary repairs before continu-
ing to work.
• Wear protective gloves when working with the
rotors.
3 ASSEMBLY
3.1 Handle, lower part (2:N)
1. Remove the nut and pull out the long screw
(2:O) at the rear under the engine.
2. Install one half of the handle's lower part and
secure using the long screw.
NOTE! The lower handle must be installed with
the upper knobs turned outwards.
3. Install the other half of the lower part of the
handle and slide in the long screw completely.
4. Screw the nut into place but do not tighten fully.
3.2 Handle, upper part (3:P)
NOTE! The nuts and screw heads must be kept
pushed in the corresponding holes in the knobs and
in the inner halves.
1. Turn the knobs (3:S) and remove the inner
halves (3:R) from the mountings.
2. Check that the catch guides are positioned and
tightened so that the markings (3:Q) are as illus-
trated.
3. Insert the upper part of the handle into the inner
catch guides and slide in the screws with knobs.
4. Install the inner halves and tighten the knobs.
3.3 Rotors (1:K)
Install the rotors on the right and left-hand rotor
axles.
Install with the two pins (1:L) and lock with the
locking pins.
3.4 Depth skid and auxiliary wheel
(1:D, E)
The depth skid and auxiliary wheel are located in
each end of the same component.
Install with the two pins and lock with the locking
pins.

3.5 Engine Oil

Unscrew the oil plug (1:M) and top up with oil as
below:
Amount: 0.6 l
Type: SAE30
Tighten the plug after topping up.