Troubleshooting - Philips HD8650 Benutzerhandbuch

Problem
The machine does not
work.
The machine is stuck in
the descaling procedure.
The coffee is not hot
enough.
The espresso does not
have enough crema.
The brewing unit cannot
be removed.
The brewing unit cannot
be placed back.
The machine grinds the
coffee beans but no coffee
comes out (see note).
The coffee is too
weak(see note).

Troubleshooting

This chapter summarises the most common problems you could
encounter with the machine. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Philips Consumer Care Centre in
your country.
Solution
Make sure the small plug is inserted into the socket. Plug in and switch on
the machine.
Make sure that the voltage indicated on the machine corresponds to the
local mains voltage.
Press the on/off button. You can restart the descaling procedure or follow
the instructions in chapter 'Descaling the machine'.
Preheat the cups. Use thin-walled cups.
Use a different type of coffee beans or adjust the ceramic coffee grinder
(see chapter 'Using the machine', section 'Adjusting the grinding degree').
Remove the coffee grounds container before you open the maintenance
door. If you still cannot remove the brewing unit follow the next steps.
Reinsert the coffee grounds container, close the maintenance door, switch
on the machine. The machine prepares for use. Switch off the machine and
try to remove the brewing unit again.
Make sure that the lever is in contact with the base of the brewing unit.
Also make sure that the hook of the brewing unit is in the correct position.
See chapter 'Cleaning and maintenance', section 'Cleaning the brewing unit'.
If you still cannot place the brewing unit back.Reinsert the coffee grounds
container and leave the brewing unit out. Close the maintenance door,
switch on the machine. The machine prepares for use. Switch off the
machine and try to place back the brewing unit again.
Clean the coffee exit duct and set the grinder to a coarser setting. Clean
the brewing unit (see chapter 'Cleaning and maintenance', section 'Cleaning
the brewing unit').
Fill the water tank with water.
Clean the coffee spout.
Adjust the ceramic coffee grinder to a finer setting (see chapter 'Using the
machine', section 'Adjusting the grinding degree').
Brew a few cups of coffee to let the machine adjust itself to the new
grinding settings.
ENGLISH
25