Troubleshooting; Troubleshooting Table - Philips 2200-Serie Bedienungsanleitung

English
24
Icon Explanation of signals
AquaClean light is flashing: place or replace the AquaClean water filter and activate
it. See chapter 'AquaClean water filter' for step-by-step instructions.
Descaling light is on: Descale the machine (see 'Descaling procedure (30 min.)').
The lights in the drink icons light up and go out one by one.
The machine is heating up and/or trying to release the air that was drawn into the
machine. Wait until all drink lights light up continuously.
The 'water tank empty'/'empty coffee grounds container' light and the alarm light are
flashing.
Reset the machine by unplugging it and plugging it back in. Before switching the
machine back on, follow these steps:
- Remove the AquaClean water filter from the water tank.
- Place back the water tank. Push it into the machine as far as possible to make
sure it is in the right position.
- Open the lid of the pre-ground coffee compartment and check if it is clogged
with coffee powder. To clean it, insert a spoon handle into the pre-ground coffee
compartment and move the handle up and down until the clogged ground
coffee falls down (Fig. 27). Remove the brew group and remove all ground coffee
that has fallen down. Place back the clean brew group.
- Switch the machine back on.
If the problem is not solved, the AquaClean filter was not prepared properly. Prepare
the AquaClean filter before placing it back by following steps 1 and 2 in chapter
'Activating the AquaClean water filter (5 min) '.
If the lights continue to flash, the machine could be overheated. Switch off the
machine, wait 30 minutes and switch it on again. If the lights are still flashing, contact
the Consumer Care Center in your country. For contact details, see the international
warranty leaflet.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the machine. Support
videos and troubleshooting content are available in the Coffee + app. On www.philips.com/coffee-
care you can find a complete list of frequently asked questions and support videos. If you are unable
to solve the problem, contact the Consumer Care Center in your country. For contact details, see the
warranty leaflet.

Troubleshooting table

Problem
The drip tray fills up
quickly.
Cause
This is normal. The machine
uses water to rinse the internal
circuit and brew group. Some
water flows through the internal
system directly into the drip
tray.
Solution
Empty the drip tray daily or as soon as
the red 'drip tray full' indicator pops up
through the drip tray cover. Tip: place a
cup under the dispensing spout to
collect rinsing water that comes out of
it.