Connecting Speakers - Yamaha RX-V459 Bedienungsanleitung

CONNECTIONS

Connecting speakers

Be sure to connect the left channel (L), right channel (R), "+" (red) and "–" (black) properly. If the connections are faulty,
no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be
unnatural and lack bass.
CAUTION
• Before connecting the speakers, make sure that this unit is in the standby mode (see page 25).
• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this
unit. This could damage this unit and/or speakers.
• Use magnetically shielded speakers. If this type of speakers still creates the interference with the
monitor, place the speakers away from the monitor.
• If you are to use 4 or 6 ohm speakers, be sure to set "SP IMP." to "6ΩMIN" before using this unit
(see page 24).
Notes
• A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Connect the striped (grooved, etc.) cable to the "+" (red) terminals of this unit and your speaker. Connect the
plain cable to the "–" (black) terminals.
• The low-frequency signals of other speakers set to "SML" (or "SMALL") to "NONE" in "SPEAKER SET" (see pages 70 and 71) are
directed to the speakers selected in "BASS OUT" (see page 71).
1
A
B
12
Front speakers (A)
Right Left
Surround speakers
Right
2
OUTPUT
SUB
WOOFER
SPEAKERS
FRONT
CLASS 2 WIRING CENTER
3
Front
speakers (B)
Subwoofer
Left
4 5 7
SURROUND
SURROUND BACK
6
Center
speaker
Surround back
speaker