Inhaltsverzeichnis
Werbung
A SHORT OVERVIEW OF SPACE FIDELITY
TOP OF THE SYSTEM
POWER
Switches the system on and off.
When the power is switched off, the set is separated
from the mains supply. (no power consumption).
POWER SOUND Toggles between three sound settings:
POWER SOUND, FLAT and USER.
IR SENSOR
Receives signals from the remote control.
Under remote control (emergency keys).
SOURCE
Selects the different sound sources and mute function
in the following order:
CD –> TUNER –> TAPE –> AUX –> MUTE –> CD.
Starts playback of a CD or cassette.
B
Stops a CD or a cassette
9
+/–
Adjusts the volume level (0 - 63)
FRONT OF THE SYSTEM
DISC /
Opens and closes the CD compartment
OPEN/CLOSE
TAPE /
Opens and closes the cassette compartment
OPEN/CLOSE
DISC SELECT
Selects the CD you wish to hear or the compartment
1...7
in which you wish to load a CD
p
This socket is for connecting standard stereo head-
phones with a 6.3 mm jack.
The system´s speaker outputs are automatically
switched off when the headphone jack is inserted,
and are automatically switched on again when it is
removed.
A SHORT OVERVIEW OF SPACE FIDELITY
DISPLAY
The display indicates
– when receiving FM stereo stations
Q R
– during station search, during fast cassette winding,
during CD search function.
B
– during CD play and cassette playback forward.
A
– during cassette playback reverse.
– when the source TAPE is selected
rec
∫
– indicates the TAPE reverse mode:
å
The tape stops at the end of each side.
∂
Playback (+ recording) of both cassette sides;
after which the tape stops at the end of the second
side.
∫
Continuous playback of both cassette sides.
– during the recording function
rec
– If the unit is optimally tuned to a radio station.
– when the source CD is selected
;
– when the system is in CD or TAPE PAUSE mode.
– when the sound is muted
kHz / MHz
– for FM reception the frequencies are indicated in MHz
and for MW reception in kHz.
########### – in this part of the display all relevant messages are
displayed.
– indicates the output signal
REMOTE CONTROL
Changing the batteries
If the range of your infrared remote control seems to decrease, or if
certain individual functions can no longer be carried out, you should
replace the batteries.
Two mignon 1.5 Volt LR03 size AAA are required.
To change the batteries, open the compartment on the back
of the remote control.
Ensure that the batteries are inserted properly
(note the markings in the compartment).
And in the interest of the environment:
Remember that batteries must always be disposed of properly.
For functional overview of remote control see next pages
kHz
MHz
Werbung
Inhaltsverzeichnis
