Switching On; Connect Fitting - GF MSA 2.0 Bedienungsanleitung

Fusion process
Next paragraphs describe step by step the interactions with the
electrofusion unit.
2.2
Before connecting the machine to the power source, please read the
Attention
chapter 6 'Technical characteristics' and check the input voltage. If a
generator is used, this has to be started before connecting the electro-
fusion unit and must supply a constant output voltage! Any sudden
changes could compromise the correct welding result and/or damage
the control unit.
Connect the machine to the power mains or generator when the
generator is already started. At power on the display shows the
machine information: machine type, software version and serial
number.
2.3
The next step consists of connecting the fitting to the machine by
the operator. The MSA 2.0 asks this with a prolonged sound.
The LED of the barcode scanner blinks to inform the operator it
has to do it.
Awaiting for that, the display shows the icon of a fitting and the
information about ambient temperature and current date/time.
10

Switching On

MSA 2.0
V 2.06
S156A6308001

Connect fitting

t = ----s
Vo= --.-V
R = --.--Ω
12/06/12 15:50
Operating Instructions MSA 2
25°C