Initial Start-Up - Webasto Thermo 50 Einbauanweisungen

Visit www.butlertechnik.com for more technical information and downloads.
Thermo50_02_gb_g.fm Seite 53 Dienstag, 27. Mai 2003 12:08 12
Thermo 50

Initial start-up

12 Initial start-up
NOTE:
The safety instructions in the operating and maintenance instructions
must be observed without fail.
The operating and maintenance instructions must be read through
without fail before starting the heater.
After installation of the heater, carefully bleed the water circuit and the
fuel supply system. Observe the regulations issued by the vehicle
manufacturer when doing this.
All water and fuel connections must be checked for leaks and secure
attachment during a trial run of the heater. If the heater switches to fault
mode during operation, the fault must be located and remedied.
53
www.butlertechnik.com