Adjusting The Appliance - EOS TSS 2003 Gebrauchsanweisung

Fasten the foot parts crosswise with the
screw (1) at the stand.
Concerning the stand heater (balcony he-
ater) TSS 2003 fi x the supportive rod with
the aid of the setscrew (2) and then push
the shim (6) onto the shaft of the heating
element aud push the heating element th-
rough the supportive rod. Push the second
shim (5) and the disk (4) onto the shaft of the
heating element and then screw the control
grip (3) lightly.

Adjusting the Appliance

You can adjust the height of the appliance
by using the setscrew (2) and you can fi x the
TSS 2003 into a horizontal (Fig.6) or verti-
cal (Fig.7) position with the aid of the control
grip (3).
When the appliance is in a vertical
position, make sure that the cable
opening is at the bottom.
10 GB
Fig.4
Fig.5
Fig.7
Fig.6