Assembly And Operation - Clearaudio Champion Magnum Bedienungsanleitung

3. Assembly and Operation

First please put on the white gloves to avoid finger prints on the surface of the acrylic chassis during
installation.
1. Place the chassis on a clean and soft surface. Please pay attention, that the surface of your Hifi-rack
is horizontal and vertical correctly adjusted, by using the delivered level gauge. Important: Never turn
the Spikes of the turntable chassis, they had been adjusted in the factory. Use the delivered Flat Pads
to avoid scratches on the surface of your Hifi-rack.
2. Now unpack your turntable platter carefully with the upper part of the bearing. Take care that the
upper part of the bearing does not fall out of the cut of the turntable platter, while unpacking. Remove
the adhesive tape from the bearing.
3. Place this unit carefully on the lower part of the
bearing spindle which is mounted in the
turntable chassis. Due to the high precision
machining there could be left some air inside
the bearing. The air will flow out after several
turns of the platter. Please make sure, that the
two markings on the turntable platter and on
the bearing are in one line (as shown in figure
below). The correct position of these markings
is very important, because they had been
calibrated at the factory.
4. Place the decoupling base for the motor in the indent of
the chassis and place the motor on it. The switch of the
motor should be on the outside of the turntable and the
space between motor and chassis approx. 1cm.
5. Place the pulley on the motor spindle. The distance between
the pulley and the motor housing should be approx. 1-2mm.
Tighten the little screws inside the pulley with the aluminium
screwdriver provided.
Seite/Page 14
Champion
 clearaudio electronic GmbH 2006
Magnum
Bedienungsanleitung
USER MANUAL