jedo Vedi Bedienungsanleitung Seite 30

Proceed as follows to complete the stroller:
1.) Now, attach the bucket seat to the frame.
2) There are two inlets each on the left and right on the frame to fasten the
bucket seat – see Figure 5.
3.) There are two bolts on the left and right on the bucket seat for insertion into
the inlets on the frame.
4.) Now, guide the two bolts on the left and right into the fastening inlets on the
frame.
5.) All four bolts will be properly inserted when you hear them click into place.
Proceed as follows to attach the hood to the bucket seat:
1.) Insert the hood with the plastic plugs into the slots on the upper end of the
arm rests of the bucket seat provided for this purpose – see Figure 19.
2.) Make sure not to jam the fabric.
3.) The hood will be properly fastened when you hear it click into place.
4.) Now pull the fabric over the backrest of the bucket seat.
5.) Use the snaps to fasten the hood on the back side.
Proceed as follows to attach the soft carrying bag and seat extension:
1.) Insert the soft carrying bag in the stroller.
2.) Pull the seat extension over the front end of the soft carrying bag.
3.) Insert the seat extension with the plastic plugs in the slots on the left and
right on the bottom end of the bucket seat provided for this purpose – see
Figure 19.
Proceed as follows to detach the bucket seat from the frame:
1.) There is a little plastic lever on the two rear bolts on the left and right of the
frame – see Figure 6.
2.) Push these down until you hear them click into place.
3.) Now, remove the shell or bucket seat.
Proceed as follows to change the direction of travel:
1.) The push rod can be set either in the direction of travel or in the opposite
direction.
2.) A lever is provided on either side – see Figure 7.
4.) Pull the upper lever towards you at the same time.
3.) The push rod will change its position.
30