jedo Vedi Bedienungsanleitung Seite 24

Poceed as follows to complete the stroller:
Proceed as follows to place the carrying shell onto the frame:
1.) Hold the carrying shell in both hands, and place it on the frame.
2.) On the right and left on the frame, there are two inlets each for fastening the
carrying shell – see Figure 5.
3.) On the left and right on the carrying shell, there are two bolts each for
insertion in the inlets on the frame.
4.) Now, inset the two bolts into the inlets on the frame on the left and right.
5.) The four bolts will be properly inserted when you hear them click into place.
Proceed as follows to attach the cover for the carrying shell:
1.) Place the cover over the carrying shell.
2.) Fix the cover in place by means of the snaps on the front cuff on the
hood.
Proceed as follows to detach the carrying shell and bucket seat from the frame:
1.) There is a little plastic lever on both rear bolts on the left and right on the
frame – see Figure 6.
2.) Push these levers down until you hear them click into place.
3.) Now remove the shell or bucket seat respectively.
Proceed as follows to change the direction of travel:
1.) The push rod can be set in the direction of travel or in the opposite direction
respectively.
2.) There is a lever on either side – see Figure 7.
4.) Pull the upper lever towards you at the same time.
3.) The push rod will change its position.
Proceed as follows to attach the napkin:
The napkin bag can be attached to the push rod by means of the two snaps.
Proceed as follows to adjust the handle height:
1.) Compress the two snaps provided on either side of the handle at the same
time – see Figure 8.
2.) The height of the push rod can now be easily adjusted.
24