jedo Vedi Bedienungsanleitung Seite 29

Sato stroller –assembly instructions
Proceed as follows to assemble the stroller:
1.) Completely remove the baby stroller from the packing.
2.) Detach the bucket seat from the frame. See the section Proceed as
follows to place the carrying shell onto the frame.
3.) Remove all the accessories from the soft carrying bag.
Proceed as follows to assemble the bucket seat:
1.) Place the bucket seat in front of you; set the backrest upright – see
Figure 9.
2.) Hold the fabric part of the seat and pull it over the backrest – see
Figure 10.
3.) Smoothen the fabric in the backrest with your hands – see Figure 11.
4.) Continue pulling the fabric over the armrests on the left and right – see
Figure 12.
5.) Fasten the snaps on the bottom end of the seat – see Figure 13.
6.) Place the belts on the floor; the lap belt should be lowermost – see
Figure 14.
7.) Pull the small belt pads over the left and right shoulder straps – see
Figure 15.
8.) Thread the left and right shoulder straps in the opening provided in the
fabric and in the plastic backrest of the bucket seat – see Figure 16.
9.) Shove the lap belt through the left and right metal hooks on the rear end
of the seat – see Figure 17.
10.) Shove the lap belt through the opening in the center on the front end of
the seat – see Figure 18.
Proceed as follows to assemble the frame:
4.) Stand in front of the stroller such that the push rod is opposite yourself.
5.) Put your foot on the axle.
6.) Embrace the push rod with both hands and pull it upwards – the stroller will
now prop up – see Figure 3.
7.) The stroller will be fully erect when you hear it click into place.
Proceed as follows to fasten the rear wheels:
1.) Make sure the rear parking brake is released.
2.) Compress the quick release fastener of the wheel.
3.) Now, slip the two wheels on the axle until they click into place – see Figure
4.
29