jedo Vedi Bedienungsanleitung Seite 26

Proceed as follows to assemble the bucket seat:
1.) Place the bucket seat in front of you, and set the backrest upright – see
Figure 9.
2.) Hold the fabric part of the seat and pull it over the backrest – see
Figure 10.
3.) Smoothen the fabric in the backrest with your hands – see Figure 11.
4.) Continue pulling the fabric over the arm rests on the left and right – see
Figure 12.
5.) Attach the snaps on the bottom end of the seat – see Figure 13.
6.) Lay the belts on the floor; the crotch belt should be at the bottom – see
Figure 14.
7.) Pull the small belt pads over the left and right shoulder straps – see
Figure 15.
8.) Hold the left and right shoulder straps and thread them into the openings
provided for this purpose in the fabric and in the plastic backrest of the
bucket seat – see Figure 16.
9.) Shove the lap belt through the metal hooks on the left and right at the rear
end of the seat – see Figure 17.
10.) Shove the crotch belt through the opening in the center at the front end of
the seat – see Figure 18.
Proceed as follows to attach the bucket seat on the frame:
1.) Now, attach the bucket seat to the frame.
2) On the left and right on the frame, there are two inlets each to attach the
bucket seat – see Figure 5.
3.) On the left and right on the bucket seat, there are two bolts each for
insertion in the inlets on the frame.
4.) Now, insert the two bolts on the left and right into the fastening inlets on the
frame.
5.) All four bolts will be properly inserted when you hear them click into place.
Proceed as follows to attach the hood to the bucket seat:
1.) Please insert the hood in the slots provided on the front end of the armrests
of the bucket seat on the left and right by means of the plastic plugs – see
Figure 19.
2.) Make sure not to jam the fabric.
3.) The hood will be properly attached when you hear it click into place.
4.) Pull the fabric over the backrest of the bucket seat.
5.) Fasten the hood using the snaps on the rear side.
26