jedo Vedi Bedienungsanleitung Seite 23

Vedi baby stroller – assembly instructions
I Proceed as follows to assemble the baby stroller:
1.) Completely remove the baby stroller from the packing.
2.) Detach the bucket seat from the frame. See the section – Proceed as
follows to attach the shell to the frame.
3.) Remove all accessories from the shell.
a.) To assemble the carrying shell:
1.) Please insert the cowl with the plastic plugs into the slots on the right
or left respectively provided on the upper end of the carrying shell edge
– see Figure 1.
2.) Be sure not to jam the fabric.
3.) The hood will be properly attached when you hear it click into place.
4.) Pull the fabric over the rear end of the carrying shell; place the elastic
band underneath the height-adjustable backrest.
5.) Fasten the hood fabric using the snaps provided for this purpose; see
Figure 2.
b.) To assemble the frame:
4.) Stand in front of the baby stroller such as to have the push rod
opposite yourself.
5.) Place your foot on the axle.
6.) Now, embrace the push rod with both hands and pull it up – the
stroller will now prop up; see Figure 3.
7.) The stroller will be fully erect once you hear it click into place.
Proceed as follows to attach the rear wheels:
1.) Make sure the rear parking brake is released.
2.) Compress the quick release fastener of the wheel.
3.) Now, slip both wheels onto the axle such that the wheels will click into place
– see Figure 4.
23