Flight Operation - Carson EasyTyrann 180 Betriebsanleitung

Equilibrating the model
The helicopter must be correctly balanced. If there is an incorrect
location of the centre of gravity, you lose the control over the
model!
The location of the centre of gravity of the model is preset.
Corrections are only necessary if you are not satisfied with the
flight characteristics.
The centre of gravity of the helicopter-model should lie exactly
in the rotation point of the rotor axis.
Shift the airplane battery in order to determine the optimal
location of the centre of gravity.
• Hang the helicopter on the upper rotor head, in the extension
of the axis of rotation. The helicopter may not tip forwards or
backwards, no matter in which position the principal rotor
blades are located.
• If the nose drops, then the model is top-heavy. Shift the airplane
battery slightly backwards.
• If the tail sinks, shift the airplane battery forward in order to adjust
the centre of gravity.
Secure the airplane battery when you have determined the optimal
location of the centre of gravity.
h. Flight Operation
Switching on the model
Ensure sufficient space in order to undertake the first flight
experiments. Even if the indoor helicopter can later be flown in the
smallest quarters, it requires about 3 m free space in all directions.
• Set the model on a smooth and level surface, so that the
helicopter can freely glide and lift off.
• Set the helicopter about 2 m in front of yourself on the ground, the
tail pointing towards you. This way the direction of reaction of the
helicopter conforms to the direction of control.
• Pull the left remote control lever (pitch) totally back.
Attention!
Switch the transmitter on first. After that, connect the freshly charged
airplane battery.
Now the model may not be moved!
• After a few seconds the model is ready to launch.
• Move the left control lever slightly forward, until the model just
lifts off from the ground.
• Pull the control lever slowly back again, so that the model gently
alights.
Move the control extremely delicately!
Lateral equilibration
Support the helicopter at the end of the tail beam and front on the
longitudinal axis as far as possible. To do this, remove the cabin hood.
The helicopter may not tip to one side, no matter in which position
the principal rotor blades are located.
CARSON Easy Tyrann 180 • 50 050 7048
GB
27