Charging The Lipo Flight Battery; Charging Via Transmitter - Carson EasyTyrann 180 Betriebsanleitung

g. Charging the LiPo Flight Battery
A. Charging via transmitter
GB
1. Turn the helicopter off.

2. Charging via transmitter:

Put down the charging wire cover of the controller and put out the
charging wire, then put it into the interface of the helicopter. The red
LED on the controller "CHA" will turn on. The charging time is about
50 - 60 minutes.
When the charging is completed, the red LED on the controller "CHA"
will turn off.
The charging time can be 50 - 60 minutes
!
The flying time is about 6 minutes.
The helicopter is equipped with a LiPo battery,
please also pay attention to the following
cautions and safety advices:
• Do not use or leave the battery near a heat source such as fire or
heater. Otherwise the battery will cause damage or explode.
• Do not slam the battery or beat to hard surface.
• Do not immerse the battery in water, and keep the battery in a cool
dry place.
26 CARSON Easy Tyrann 180 • 50 050 7048
B. Charging via USB cable
3. Charging via USB cable:
Put the USB charging wire into your computer USB interface, the
charging wire will be lightened. Put the other side of the USB charging
wire into the helicopter's interface. The USB charging wire light will be
turned off. The charging time is about 50 - 60 minutes. The charging
wire light will turn on, then the helicopter is fully charged.
• The charger included with this product can only be used for the
product's charge.
• Do not disassemble the battery.
• Never leave the battery unattended during charging.
During the charge, move the power switch of
the helicopter to "OFF".