Install Flight Battery; Equilibrating The Model - Carson SA315B Lama Betriebsanleitung

h. Install Flight Battery
1. Open the battery compartment lid.
2. Insert the battery into the battery compartment.
3. Leave the connecting lead hanging out and then replace the lid on
the battery compartment.
i. Equilibrating the Model
The helicopter must be correctly balanced. If there is an incorrect
location of the centre of gravity, you lose the control over the model!
The location of the centre of gravity of the model is preset.
Corrections are only necessary if you are not satisfied with the flight
characteristics.
The centre of gravity of the helicopter-model should lie exactly in the
rotation point of the rotor axis.
Shift the airplane battery in order to determine the optimal location
of the centre of gravity.
• Hang the helicopter on the upper rotor head, in the extension
of the axis of rotation. The helicopter may not tip forwards or
backwards, no matter in which position the principal rotor blades
are located.
• If the nose drops, then the model is top-heavy. Shift the airplane
battery slightly backwards.
• If the tail sinks, shift the airplane battery forward in order to adjust
the centre of gravity.
Secure the airplane battery when you have determined the optimal
location of the centre of gravity.
• Connect the Lipo Balance charger to the power supply's cable.
• Connect the LiPo battery's white balance connector to the LiPo
Balance charger.
• The battery is completely charged when the green led lights up
permanently.
Lipo Balance
charger
Lateral equilibration
Support the helicopter at the end of the tail beam and front on the
longitudinal axis as far as possible. To do this, remove the cabin hood.
The helicopter may not tip to one side, no matter in which position
the principal rotor blades are located.
CARSON Air Zermatt SA 315B „Lama" 50 050 7041
GB
39