Preparations; General Remarks; Charging And Installation Of The Airplane Batteries - Carson BIG EC-135 Betriebsanleitung

e. Preparations
GB

General remarks

• If you have no or little experience with airplane models, you
should first practice with a Flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the
transmitter.
• Begin your flight experiments standing behind the model,
the line of sight in the flight direction. In this case, the control
reaction is the same as the direction of control.
Furthermore acquaint yourself with the control of the model as
it comes towards you (side-inverted reaction to the direction of
control)!
Lipo Balance Charger
Push the airplane battery from the rear
into the recess in the fuselage.
• Thread the battery cable under the fuselage through the
running gear (1) and
• connect to the battery with the flight controller.
If you run the battery cable above the fuselage, the cabin hood
can only be attached with difficulty.
To dismantle the battery, proceed in the opposite sequence.
16 CARSON Helikopter BIG EC-135 507014
Charging and installation of the airplane
batteries
Always charge the battery outside of the model!
• Connect the battery charger with the battery adapter.
• Plug the plug battery charger in a power socket.
• Put the battery in a metal bowl and
• Connect the battery with the battery charger.
• Make sure that the connector is inserted correctly to avoid a
short circuit.
• Do not cover the battery!
The charging time for the Helicopter battery is 90 minutes.
Do not charge the battery for longer than the specified time,
since excessive charging may result in overheating and
damage to the battery.
The temperature of the battery should not exceed 60°C during
the charging process.
The battery will not be fully charged if it is not charged for the
full 90 minutes. This will influence the flight time and the flight
characteristics.