Inhaltsverzeichnis
Werbung
LIpo battery cHargIng
the helicopter is fitted with a LiPo battery.
3.7 V LiPo battery.
The supplied LiPo battery is stored in the body of the helicopter.
Charging via the radio control unit:
-
Switch the radio control unit ON
-
Switch the helicopter OFF
-
Connect the USB charging cable between the radio control
unit and the helicopter (remove rubber protective cap)
-
Power LEDs on the transmitter and USB connector glows red
(charging battery)
-
LED goes out: battery is charged
Charging from a computer USB connection:
-
Switch the helicopter OFF
-
Connect the USB charging cable between the computer and
the helicopter (remove rubber protective cap)
-
USB connector LED glows red (charging battery)
-
LED goes out: battery is charged
important: after charging, replace the rubber protective cap!
get tHe HeLIcopter reaDy For takeoFF
Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
1
Push the throttle lever fully down and then switch on the trans-
mitter.
3
Now move the throttle lever completely up and then back down.
Now the helicopter is ready to launch.
on/
oFF
1
1
ON/OFF
switch
2
Switch the helicopter on and place it on a level surface.
2
2
23 // GB
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
