Information On Cables And Connections; Audio Connections; Cables And Plug Configurations - Fohhn Arc-Top active Bedienungsanleitung

7. Information on cables and connections

7.1 Audio connections

Before connecting the Top active to the mains power supply, make
sure that the mains voltage corresponds to that specified on the
operating panel (tolerance of +/- 10% is permitted). Always plug
in the mains cable before switching on the Top active and always
switch off the Top active before disconnecting it from the mains
power supply.
All other cables should be connected when the Top active is
switched off and the mixing desk should be switched on before
the Top active is switched on. This prevents annoying and often
dangerous switch-on noises.

7.2 Cables and plug configurations

When connecting a mixing desk to the Top active, always make sure
the screened cable is intact. Unscreened cables may cause problems
relating to signal or hum interference. When connecting a passive
speaker to the Top active, please use high-quality SPEAKON cables.
Check the condition of your cables on a regular basis.
Speakon
XLR
2 1
+1 +2
3
-1 -2
T
T S S
T
T R S S
R
2
XLR Male
3
1
2
3
1
38 | Top active
Jack
T R S
XLR Female
XLR-RJ45 adapter cable
USB cable
Type 3-pin XLR (male)
GND / Shield Pin 1
DATA+ Pin 2
DATA- Pin 3
Fohhn Audio Soft - Version 2.2.0
8-pin RJ-45
Shield
Pin 3 + Pin 6
Pin 4 + Pin 5
necessary!