Fohhn Arc-Top active Bedienungsanleitung Seite 33

(15) signal / clip LED ch1
Signal / clip LED: Lights up green when the input signal is
available, turns red when the input signal (from the mixing
desk, keyboard, etc.) or the output signal of the amplifier is
too high.
(14) signal / clip LED ch2
Signal / clip LED: Lights up green when the input signal is
available, turns red when the input signal (from the mixing
desk, keyboard, etc.) or the output signal of the amplifier is
too high.
STATUS FRONT LED
(40) Status front LED
After switching on the power (2) the blue
status front LED (40) is activated.
BACKLIGHT
You can switch off the blue background lighting for the display
(40) and the blue front LED (21) here. The display can still be
operated when the lighting is off: pressing a button on the
display switches the display lighting back on, the lighting then
switches off automatically after a few seconds.
When switching "off" backlight the lighting switches off
automatically after a few seconds.
Setup / Display / Backlight
Contrast
Backlight
SIGN
You can only start this function via Fohhn Audio Soft!
Pressing the blue illuminated button causes the display (21)
and the front LED (40) on the connected device to flash.
This function is extremely useful if you are working with several
devices. The SIGN function enables you to easily find out which
device you are currently working with.
+4
off
Fohhn Audio DSP
(21) Display
Clearly laid out 4-line display. All information and settings
relating to the Fohhn Audio DSPs can be viewed on this
display.
Important
1. Keylock: Display lock protects against unauthorised
access: Setup / Keylock ON/OFF
2. Backlight: You can switch off the blue background
lighting for the display (40) and the blue
front LED (21)
Setup / Display / Backlight ON/OFF
(20) Select potentiometer
The relevant selected values on the display are modified by way
of this input potentiometer. Pressing the potentiometer resets
the input value to its initial value.
(22) Navigation Keys
(23)
You can move to the previous or next line by pressing the Up
(24)
(24) / Down (25) buttons. The arrows > < move every time
(25)
these buttons are pressed and indicate which line is currently
active.Pressing the
Enter button (22) opens the corresponding submenu.
Press Exit (23) to return to the previous screen.
REMOTE CONTROL RS-485
Network connector
(26) RS-485 network connection jacks
(27)
The network cables are connected to the IN (26) and OUT (27)
sockets.
See also separate user instruction „Software Handling"!
(28) receive LED
LED indicates that the X-Sub active is receiving data.
(29) send LED
LED indicates that the X-Sub active is sending data.
See also separate user instruction „Software Handling"!
Fohhn Audio Soft - Version 2.2.0 necessary!
Top active | 33