Information On Cables And Connections; Audio Connections; Cables And Plug Configurations - Fohhn Linea Serie Bedienungsanleitung

7. Information on cables and connections

7.1 Audio connections

Before connecting the X-Sub active to the mains power supply,
make sure that the mains voltage corresponds to that specified on
the operating panel (tolerance of +/- 10% is permitted). Always
plug in the mains cable before switching on the X-Sub active and
always switch off the X-Sub active before disconnecting it from the
mains power supply.
All other cables should be connected when the X-Sub active is
switched off and the mixing desk should be switched on before
the X-Sub active is switched on. This prevents annoying and often
dangerous switch-on noises.

7.2 Cables and plug configurations

When connecting a mixing desk to the X-Sub active, always make
sure the screened cable is intact. Unscreened cables may cause
problems relating to signal or hum interference. When connecting
the satellite speakers to the X-Sub active, please use high-quality
SPEAKON cables. Check the condition of your cables on a regular
basis.
XLR
2 1
3
T S
T R S
2
3
1
2
3
1
34 | Linea Live
Downloaded from www.Manualslib.com
Speakon
Jack
+1 +2
-1 -2
T R S
T
S
T
S
R
XLR Male
XLR Female
manuals search engine
XLR-RJ45 adapter cable
USB cable
Type 3-pin XLR (male) 8-pin RJ-45
GND / Shield Pin 1 Shield
DATA+ Pin 2 Pin 3 + Pin 6
DATA- Pin 3 Pin 4 + Pin 5
Fohhn Audio Soft - Version 2.x ! necessary!