STRAIGHT CORE GWP-106VE Betriebshandbuch Seite 5

1.4.2.1
Standard Power Injector
In the standard variant the unit is delivered with a standard injector without the integrated switch. The
connection is easy. Connect the Ethernet cable from your PC or the switch into the port marked LAN. The
POE port is used for the connection of the cable leading to the ODU unit. Connect the delivered network
adapter into the port of the described DC – now the installation is complete. Attention, in the case of
incorrect connection of cables into individual ports there can be serious damage to your switch or
computer. Therefore, we recommend to use for this connection a Cat.3 4 or 5 cable with only 1,2,3 and 6
contacts connected. In this case there is no risk of damage because the POE system uses transfer on
contacts 4/5 and 7/8 as schematically displayed on the upper side of the POE injector.
It is possible to use side clamps and small screws for mounting of the injector on the wall which is
not part of the delivery. The span of the assembly holes is 68 mm.
1.4.2.2
PSW-105/205
The optional accessory to the GWP-106VE unit is the PSW-105/205 projector with an integrated 4-
pole switch. This variant is equipped with an LED diode for checking the function. The description of the
status and the function of individual LED diodes are in the following table:
LED Colour
Power Orange
Green
1-4/POE Orange
Red
5 Green
1.4.2.2.1.
The IDU PSW-105 is equipped with a POE system (Power-over-ethernet). In the standard configuration the
PoE is active only on port No.1 which is used for the supply of the unit. In special cases, by interconnection
of the J1 switch on the board of the switch it is possible to also switch the ON supply for ports 2-4 and to
supply up to 4 external units with one PSW-105 switch (in this case , it is necessary to replace the delivered
source with the 12V/2A source). Further options for the use of this regime is, for example, the installation of
one switch for PC with an active POE port 1 and the supply of a distant switch in the regime of 4 POE ports
by means of the POE system. It is possible to use the remaining 3 ports for connection of 3 external GWP-
207VE units.
For fast specification of the configuration of PSW-105, connect only the supply voltage. The ports on which
the POE system is active are indicated by a permanently lit red LED diode.
1.4.2.2.2.
The DC-12V connector serves for the connection of the supply voltage. The standard delivery includes the
12V/500mA source which is sufficient for the operation of the switch and one unit on the cable with a length
of 15 m. In the case of operation with a longer cable, it is possible to use for the supply a stabilized
maximum 18V source. With the increase of the input voltage it is possible to ensure stable operation up to
70 m of the Ethernet line. In the case of connection of further units to one PSW-105, it is necessary, on the
contrary, to increase the input current. For each connected unit it is necessary to consider the current as
400mA and for each remotely supplied switch the current as 100mA.
English version
Status
ON
OFF
OFF
Red
Orange ON
Orange, flashes Line connected, POE active, data transfer
Green ON
Green flashes
ON
Flashes
OFF
POE System
Supply of IDU/Connection of further units
Description
Supply to the unit is connected
No supply
Line disconnected, POE inactive
Line disconnected, POE active for respective port
Line connected, POE active for respective port
Line connected, POE inactive
Line connected, POE inactive, data transfer
Line connected.
The line is transmitting or receiving data.
Line disconnected
5
Introduction