Wan Port Tcp/Ip Setting; Gateway And Routing - STRAIGHT CORE GWP-106VE Betriebshandbuch

2.5.2 WAN port TCP/IP setting

On this page you can define the settings for the wireless interface, directed to the Internet. These settings
will not be used when the unit is in BRIDGE mode. This page is dynamic and changes according to the
Internet connection type currently selected. The suitable connection type is determined according to the
application mode or your connection provider. There are 5 types in total:
2.5.2.1
Static IP address
The IP Address is set manually to the device in this mode. In addition to the IP Address, Gateway and
Mask you can set three DNS servers to back each other up. The last item entered is the possible MAC
Address definition for the WAN interface.
2.5.2.2
DHCP Client
When using the DHCP Client setting, you can define the manner of assigning DNS server information, or
WAN Port MAC Address only. The other TCP/IP parameters are assigned automatically by the parent DHCP
server.
2.5.2.3
PPPoE
PPPoE (Point-To-Point Protocol over Ethernet) settings are often used by Internet connection providers.
It is simple method of authenticated connection, secured with the name and password specified in the
configuration. In addition, the type of connection is defined (Permanent, At Request, Manual), automatic
disconnect timeout and maximum transmit packet length. You can also manually define the MAC interface
Addresses.
2.5.2.4
PPTP
PPTP setting is used for the automatic connection to a Virtual Private Network. Connection is defined by
the Server IP Address, Username and Password. Again you can define the MTU, DNS servers and interface
MAC Addresses, next MPPE or MSCHAP encryption type. Contact the VPN network administrator to acquire
the parameters for connection.
2.5.2.5
PPTP+DHCP
This option is used for connection to the VPN network as before, although the local IP address is
acquired from the DHCP server located in the given VPN.

2.5.3 Gateway and Routing

The page "Gateway and routing" is used for defining static items of the routing table to ensure the correct
functioning of the Unit in "Router mode". To set these parameters you need to know the network structure
and where the unit is installed. "Default Gateway" defines the border router, to which all packets with non-
defined routing will be sent (an automatic or manually set up routing rule).
English version
Configuration of the wireless access point LAN
15
17