JUMO dTRANS T02 LCD Betriebsanleitung Seite 51

Configuration level
You can access the configuration level from the parameter level by
pressing the q button (for at least 2 seconds).
H
The parameters can only be modified when the parameter
OFFS is active in the display and the configuration level has
been started. If another parameter is active, you can only
read the current setting.
The following functions can be programmed at this level:
- Probe type
- Linearization
- Number of decimal places
- Unit of measurement
- Supply frequency and temperature compensation
- Fixed value for temperature compensation
- Measurement display
- Function of the analog output
- Signal on probe break/short-circuit
- Function of the logic output 1
- Signal on probe break/short-circuit
- Lower switching differential (hysteresis)
- Upper switching differential (hysteresis)
- Function of the logic output 2
- Signal on probe break/short-circuit
- Lower switching differential (hysteresis)
- Upper switching differential (hysteresis)
4 Functions and operation
13
C111
C112
C113
C002
C114
C115
C116
C211
C212
C221
C222
C223
C224
C231
C232
C233
C234