Running And Operating The Start Set - FLEISCHMANN multiMAUS 990001 Kurzanleitung

4 Running and Operating
with the Start-Set
4.1 Putting vehicles on the Track
Place the railer device included in the
START-SET onto a straight section of track
and then put the vehicle on the railer
(Fig.11). Now simply push the vehicle down
onto the track.
4.2 The Direction of Running
Analog: Place the loco on the track and
turn the control knob to the left – the loco
will run to the left (Fig. 12.1). Turn the con-
trol knob to the centre position, and the
loco will come to a halt. Turn to the right
and the loco will run to the right (Fig. 12.2).
If the direction of your loco is reversed,
then simply swop over the two yellow wires
at the controller.
49