Inhaltsverzeichnis
Werbung
track to the yellow clips on the controller
(Fig. 5). Simply depress the yellow clips
and insert the unisolated ends of the wires
into the side of the opening (Fig. 6). On
releasing the clips, the wires will be held
securely in position. Couple up the control-
ler and mains unit using the cable provided,
and plug in the mains plug into a standard
socket or extension lead (Fig. 7) – your
model railway layout is ready to run.
3.3 Connecting up the multiMAUS
digital controller (DCC) (Fig. 8 - 10)
If a multiMAUS digital controller is included
with your START-SET:
Connect your multiMAUS as described in
the respective operating instructions. To do
so, at first you will have to connect the
supplied current-feed clips to the tracks.
As shown in figures 8 and 9, clip on the
track feed clips under a piece of straight
track. Snap in clip "1" by pressing the
47
Werbung
Kapitel
Inhaltsverzeichnis
