HAPRO Mobile Sun HP8540 Bedienungsanleitung Seite 6

ENGLISH
8
6 Lie down under the lamp unit.
- The appliance beeps during the last minute of the session.
- During this minute, you can reset the timer to tan the other side of your body. If you reset
the timer during this minute, you avoid the 3-minute waiting time which is necessary to let
the tanning lamps cool down after they have switched off.
- The timer automatically switches off the tanning appliance when the set tanning time has
elapsed.
After the tanning session
1 Use the memory knobs to keep track of the number of tanning sessions you have had.
The appliance has two memory knobs: one for each person (Fig. 13).
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or
acetone to clean the appliance.
Do not let any water run into the appliance.
1 Unplug the appliance and let it cool down before you clean it.
2 Clean the outside of the appliance with a damp cloth.
3 Clean the outside of the UV filter with a soft cloth sprinkled with some methylated
spirits.
4 Clean the protective goggles with a moist cloth.
Storage
1 Let the appliance cool down for 15 minutes before you put it in transport position and
store it.
2 In the meantime, you can wind up the cord and put it in the base of the appliance.
Note: Make sure the cord is stored properly and does not get stuck between the hinging parts
of the appliance when you put the appliance in transport position.
3 Slide the collar down the stand (1) to unlock the height adjustment lock. Push the stand
down at the same time (2). Then let go of the collar (Fig. 14).
4 Turn the lamp unit a quarter turn (Fig. 15).
5 Lift the lamp unit a little with one hand (1). Push down the two unlocking slides with
your other hand (2) to be able to fold the lamp unit (3) (Fig. 16).
6 Hold the two unlocking slides down with one hand and fold the lamp unit into vertical
position with your other hand. Then let go of the unlocking slides (Fig. 17).
7 Lower the stand and the lamp unit carefully onto the base of the appliance (Fig. 18).
8 Push the slides on the base in the direction of the arrow to lock the lamp unit onto the
base (Fig. 19).
9 Store the tanning appliance.
- You can store the tanning appliance under a bed (Fig. 20).
- You can also store the tanning appliance in a cupboard in upright position (Fig. 21).