Changing The Blade - Coitech 92107L Bedienungsanleitung

Changing the blade

1. Unplug the machine.
2. Pull out the locking pin (17) and carefully lift the saw head.
3. Press in the spindle lock (18) with one hand and turn the blade with your other hand until it locks.
Keep the spindle lock pressed in and undo the blade flange bolt with the spanner (turn clockwise).
4. Remove the flange bolt and the outer flange.
5. Take the blade off the inner flange and pull it out.
6. Mount the new blade in the reverse order.
7. Clean the saw blade flanges and bolt thoroughly before mounting the new blade.
The direction of rotation of the blade must be the same as the arrow on the housing.
8. Make sure the spindle lock is off.
9. Before using the saw again, make sure that all safety devices are in good working order.
Note! The spindle has a 16 mm diameter and an insert ring is fitted with the original blade that
has a 30 mm diameter. The saw can be used with blades with either a 16 mm or 30 mm bore.
Warning! Every time you change the blade, make sure that it spins freely in all angle settings.
Warning! Remove the spanner and release the spindle lock before switching the machine on.
Laser
This saw is equipped with a laser that projects
a laser cutting line onto the workpiece. The laser's
on/off switch is located on the battery compartment.
11
Laser`s
on/off switch