Coitech 92107L Bedienungsanleitung Seite 8

Cross Cutting
Making 90° crosscuts with the turntable at 0°
When cutting workpieces up to 100 mm in width the slide function is not needed and the saw can be locked in
the rear position using the rail locking knob (15). For cutting workpieces wider than 100 mm, you must ensure
that the locking knob (15) is slackened and that the saw head (4) can be moved.
1. Raise the saw head (4) to its upper position by releasing the lock (17).
2. Push the saw head (4) back by its handle (2) and fix it in this position if necessary (depending on
the cutting width).
3. Place the workpiece against the fence (7) on the turntable (8).
4. Secure the workpiece to the base using the clamp (20) to prevent it from moving during the cutting process.
5. Press in the on/off switch to start the motor, turn the release lever and carefully lower the handle (2).
Let the saw cut through the workpiece.
6. When the cutting process is finished: Release the on/off switch (3). When the motor has stopped, the saw
head (4) can be brought back to its upper position.
Warning! The resetting springs in the machine automatically raise the saw head after cutting. Do not simply
let go of the saw head (2) after cutting, hold onto the handle and let it come up slowly.
17
8