Cleaning And Care; Emptying The Dust Container; Cleaning The Filters - Beko VCO 42701 AB Bedienungsanleitung

4

Cleaning and care

Switch off and unplug the appliance before
cleaning it.
WARNING: Never use gasoline,
A
solvent, abrasive cleaning agents,
metal objects or hard brushes to
clean the appliance.
4.1 Emptying the dust
container
1. Press the dust container removal button (8) to
remove the dust container (4) and remove the
dust container in the direction of the arrow by
holding from the dust container carrying handle.
2. Open the lid of the dust container (4) by pressing
the inner latch and empty the container.
3. When you have emptied the dust, close the dust
container lid (4).
– A click will be heard.
4. Insert the dust container (4) into its place by
holding it from the handle.

4.2 Cleaning the filters

A
WARNING: Do not use appliances
producing hot air such as hair dryer
or heater to dry the filters.
WARNING: Do not install the
filters without completely drying
A
them; otherwise, smell of moisture
may occur during use, water can leak
from the back of the appliance or the
filters may get damaged.
10 / EN
A
WARNING: Attach the filters into
their places after they have dried.
4.2.1 Motor protection filter and
HEPA filter
These filters are located on the rear side of the
dust container (4).
1. Press the dust container removal button (8) and
remove the dust container (4).
2. Remove the HEPA filter and motor protection
filter found at the back of the dust container (4).
3. After washing the sponge protection filter
under running water, wring it out slightly and
leave it to dry (for 24 hours minimum).
4. Shake off the HEPA inlet filter to eliminate
the dusts on it. After that, you can wash it by
holding its clean side under running cool water.
5. If you wash the HEPA filter, dry it at room
temperature (for 24 hours minimum). Do not
use it before ensuring that it is completely dry.
Vacuum Cleaner / User Manual