Troubleshooting; Technical Data - Cleanmaxx 02304 Gebrauchsanleitung

Troubleshooting

If the device stops working properly, fi rst check whether you are able to correct the
problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device only works
slowly or does not start.
Low suction force.
The control lamp does
not light up when the
device is connected to
the mains power.
Streaks when cleaning
windows or smooth
surfaces.

Technical Data

Article numbers:
– 00332 (limegreen)
– 02304 (yellow)
– 01147 (blue)
– 01599 (turquoise-white)
Device
Model:
Voltage supply:
Power:
Battery charge time:
Battery operating time:
Protection class:
Capacity:
21
Possible cause/solution
• Is the battery fl at? Recharge it.
• Is the collecting container (5) full? Empty it.
• Is the suction opening blocked? Switch off the device
and remove the blockage.
• Is the mains adapter (7) plugged correctly into the plug
socket and is the jack plug in the connecting socket of
the device?
• Is the plug socket defective? Try another plug socket.
• Check the fuse of your mains connection.
• Clean the scraper lip.
• Turn over a worn scraper lip: Pull the scraper lip
sideways out of its holder, moisten with water or
cleaning agent in the rounded area and slide back into
the holder the other way round.
• Replace the scraper lip if necessary: If after turning the
scraper lip over both edges are worn, a new scraper lip
is required. Replace the scraper lip.
• Check the metering of the cleaning agent.
HL-3202
3.7 V DC (1 x Li-ion battery,
18650 type), 1500 mAh
10 W
approx. 3 - 3.5 hours
approx. 20 - 28 minutes
III / IPX6
100 ml
EN