Troubleshooting - Cleanmaxx SV1801A Gebrauchsanleitung

EN
Cleaning the Dust Container and HEPA Filter
1. Press onto the dust container (4) to unlock it.
2. Reach into the recess in the dust container and pull it up and out of the motor unit (3).
3. Reach into the opening and pull the HEPA-fi lter out of the dust container.
4. Empty the dust container.
5. Wipe out the dust container with a dry duster if necessary.
6. Tap out the HEPA-fi lter and clean it with a soft brush if necessary. Please note: For
thorough cleaning the fi lter can be rinsed under cold (!) running water.
NOTICE: Allow the HEPA-fi lter to dry completely before the device is reassembled.
7. Insert the HEPA-fi lter into the dust container.
8. Insert the dust container into the motor unit. It must audibly click into place.
Cleaning the UV-C Lamp
PLEASE NOTE!
■ CAUTION – Danger of Burns! The UV-C lamp will become hot during use. Allow the
UV-C lamp to cool suffi ciently after using the device.
1. Undo the two screws on the cover (8) of the UV-C lamp (11) and take off the cover.
2. Wipe down the UV-C lamp with a dry duster. NOTE: Make sure that you do not touch
the UV-C lamp with your fi ngers!
3. Place the cover back on and fi x it in place with the two screws.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair a electrical device yourself!
Problem
The device
generates no
suction.
Low suction
force.
Possible cause / solution / tips
• Is the mains plug inserted in the socket correctly? Correct the
fi t of the mains plug.
• Is the plug socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the device switched on? Press the On / Off switch (1).
• Is the dust container (4) too full? Empty the dust container.
• Is the fi lter heavily clogged up? Clean the fi lter.
• Is the suction opening (7) blocked? Switch off the device, pull
the mains plug out of the plug socket and remove the blockage.
18