For Users And Technicians; Instructions For Use; Safety Advice; Your New Device - Bosch TR5500T 80 Montage- Und Gebrauchsanweisung

6

For Users and Technicians

6.1

Instructions for Use

Before you use the device, please read this instruction manual carefully!
6.2

Safety advice

• This device is intended for household or household-like use, not for
commercial purposes.
Household-like applications include, for example, use in staff
kitchens of shops, offices, agricultural and other business
operations, as well as use by guests in hostels, small hotels and
similar living facilities.
WARNING:
▶ Danger of electric shock!
In the case of a fault, disconnect from the voltage
supply.
▶ We are not liable for any damages which arise due
to failure to observe the instructions in this
manual.
▶ The hot water wall storage unit may only be
installed and brought into operation by a
technician.
• In order to avoid hazards, repairs may only be carried out by a
customer service operator licensed by us.
• The hot water wall storage unit must be installed in a frost-free room.
• This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the
6.4

Control Panel

Fig. 2
1. anode LED
2. service LED
3. fast-heating LED
4. fast-heating button
5. heat content LEDs
6. water temperature dial
6.5

Service and Operation

The hot water temperature may be set
dial. We recommend the setting of 60°C. Heat wastage and calcification
are lowest here.
Upon reaching the set temperature all 6 thermal capacity indicators
LEDs light up. As hot water is extracted the amount of hot water available
in the reservoir decreases. The less hot water available, the fewer LEDs
are lit up.
TR5500T – 6 720 875 993 (2017/12)
between * and 85°C using the
appliance. Cleaning and user maintenance shall not be made by
children without supervision.
• Keep children away from the device. Supervise children to prevent
them from playing with the device.
• The mixing tap and the hot water pipe can become hot.
• In the case of a fault please switch off the fuse immediately.
• Please warn children that the water can get hot.
In the case of a leak on the device, shut off the cold water supply line
immediately. Only allow the fault to be repaired by customer service
technician or a qualified specialist company.
• If the reservoir has not been used for more than three months, it must
be flushed out until no more air bubbles escape. When the device is
full with water and functions normally (there are no faults apparent),
the device cannot be separated from the mains voltage for long
periods of time, otherwise the external power source anode stops
functioning and the device rusts through. For complaints of this
nature, the warranty and guarantee do not apply.
Read also the detailed safety sentence at the beginning of the
manual and to observe them!
6.3

Your new device

The hot water storage units TR5500T 80... – TR5500T 150... with
electronic control are designed for the heating of drinking water
according to DIN 1988.
They can provide hot water to 85°C and, depending on the mode of
operation, service one or more taps (tapping points). The water is
heated electrically. On the control panel the current amount of available
hot water is displayed by 6 LEDs. The hot water storage units are
equipped with an active, electronic corrosion protector (external power
source anode).
The heating period is dependent upon the volume of water in the
reservoir, the cold water intake temperature, and the set heat output.
See technical data table (page 16)
The hot water storage unit may be used optionally for
closed (pressurised) operation
suitable for service of multiple tapping points
open (de-pressurised) operation
suitable for service of one tapping point
There are three variations of electrical connections to choose from:
Single-power operation
Reheating occurs automatically subject to the power supply.
The button "fast-heating" is only used for the reset and diagnostic
routine functions (technician).
Double-power operation
During off-peak periods, the hot water storage unit automatically
heats the contents of the reservoir at the configured basic perfor-
mance. The quick heating may be activated by pressing the fast-heating
For Users and Technicians
19