In Case Of Fault - Bosch TR5500T 80 Montage- Und Gebrauchsanweisung

5

In case of fault

If your device does not function as intended, it is usually due to a small
detail. Please check whether or not the fault can be self-repaired
according to the following indicators. You will thereby avoid the costs of
an unnecessary repair service.
In normal operations, the LED "anode"
"service" is off.
If one of the two LEDs flashes, this indicates an "error condition".
In case of fault, do not disconnect the power supply line.
In order to possibly remedy the error condition oneself, there are two
procedures:
RESET: To begin with, please reset the device
proceed as follows:
Fig. 1 Heat content display indicators (LED)
TR5500T – 6 720 875 993 (2017/12)
Firstly, turn the dial
After that, press the "fast-heating" button
If the cause of the "error condition" does not exist directly after the
reset, the device will again return to its normal mode of function.
is constantly lit, the LED
Otherwise the device will again indicate an "error condition".
Diagnostic routines: In order to better define the "error condition", the
device uses diagnostic routines. Please activate the program as follows:
Push and hold the button "fast-heating"
The type of fault will now be displayed by the 6 hot water content LEDs
RESET. To do this,
to the setting " ● ".
as presented in the following table:
In case of fault
.
for at least 5 seconds.
17