Atmosphäre hin offen gelassen werden. • Das Sicherheitsventil verhindert, dass sich ein unzulässiger Über- druck im Speicher während des Aufheizens bildet. Ausdehnungswas- ser muss über das Sicherheitsventil abfließen können. • Die Abflussleitung darf nicht verschlossen werden! TR5500T – 6 720 875 994 (2017/12)
Reset- oder Diagnose- funktion genutzt. Anschluss mit Niedertarif-Kontakt: Wird die Taste Schnellheizen betätigt, heizt das Gerät einmalig bis zur eingestellten Temperatur auf. Das Gerät schaltet sich anschlie- ßend wieder automatisch ab. TR5500T – 6 720 875 994 (2017/12)
Seite 4
Positionen 5 / 6 / 7 der „Zweikreis“ Schaltung einstellen. Einkreis Leistungsschalter „S1“ auf der Elektronik in die Positionen 1 / 2 / 3 / 4 „Einkreis“ Schaltung einstellen Abhängig von der Hausinstallation sind folgende Anschlussvarianten möglich: Siehe Tabelle empfohlene Anschlussarten Einkreisschaltung TR5500T – 6 720 875 994 (2017/12)
1 - 3 kW 2/N/PE~400 V min 10 A // max 16 A Grund-Leistung (min. xx A) 2/N/PE~230 V 2 - 3 kW 2/N/PE~400 V min 10 A // max 16 A Absicherung für Stark-Leistung (max. xx A) TR5500T – 6 720 875 994 (2017/12)
Zurücksetzen nicht mehr besteht, setzt das Gerät wieder seine nor- male Betriebs-Funktion fort. Andernfalls geht das Gerät wieder in 1. Anode LED den „Fehlerzustand“ zurück. 2. Service LED 3. Stark Heizung LED 4. Stark Heizung taste 5. Temperatur Drehknopf TR5500T – 6 720 875 994 (2017/12)
Mitarbeiterküchen von Läden, Büros, landwirtschaftlichen und ande- Ihr neues Gerät ren gewerblichen Betrieben, sowie die Nutzung durch Gäste von Pen- Die Warmwasser Wandspeicher TR5500T 30 EB mit elektronischer Re- sionen, kleinen Hotels und ähnlichen Wohneinrichtungen. gelung sind für die Erwärmung von Trinkwasser nach DIN 1988 vorgese- hen.
Bedarf durch Drücken der Taste Schnellheizen eingeschaltet werden. Während das Gerät aufheizt leuchtet die LED und erlischt sobald die eingestellte Temperatur erreicht ist. Die Schnellheizung schaltet sich wieder automatisch aus. Änderungen vorbehalten. TR5500T – 6 720 875 994 (2017/12)
• Do not use aggressive or abrasive cleaning detergents! • Do not use a steam cleaner. • The appliance is only to be descaled by a suitably qualified specialist. Please observe the manufacturers warnings when decalcifying. TR5500T – 6 720 875 994 (2017/12)
Connection without off-peak contact. The reservoir heats with the configured basic performance. The “fast-heating function” activates a heating cycle at higher installed power in order to accelerate the heating-up procedure. To start this TR5500T – 6 720 875 994 (2017/12)
“single power”. the cover. Boiler mode Depending on the home installation, the following connection variations are possible: Refer to the connection types recommended for boiler switch. TR5500T – 6 720 875 994 (2017/12)
1 kW 2/N/PE~400 V // 2 x min 10 A 2 kW 2 kW 2/N/PE~400 V // 2 x min 10 A Secure load 3 kW 3 kW 2/N/PE~400 V // 2 x min 16 A TR5500T – 6 720 875 994 (2017/12)
Flashing Internal electronic failure Reset, if the problem remains please contact technician. Technician On/Off Check that the reservoir is filled. Flashing Anode fault Technician (see below) If the problem remains please contact technician. TR5500T – 6 720 875 994 (2017/12)
Children shall not play with 3. fast-heating LED the appliance. Cleaning and user maintenance shall not be made 4. fast-heating button by children without supervision. 5. water temperature dial TR5500T – 6 720 875 994 (2017/12)
If the cause of the error condition does not exist directly after the reset, the device will again return to its normal mode of function. Otherwise the device will again indicate an “error condition”. In this case please contact the customer service operator. Subject to change. TR5500T – 6 720 875 994 (2017/12)
Seite 20
Vom Elektrizitats-Versorgungs- Unternehmen geschaltet Connected by electric supply company In jedem Fall kann die Variante 15.3 nicht mit E2-Anschluss verwendet werden In any case, the variant 15.3 can be used with E2 connection 15 15...