Schneider SCD 400 A++ NF IX Bedienungsanleitung Seite 61

 The settings of the temperature of both the fridge and freezer can be adjusted
manually by pressing the relevant buttons (button "R
of the compartment = fridge or freezer / button "T
setting of the temperature in the respective compartments) until the desired
values will be indicated (s. chapter 4.3 O
 When you set a temperature, you set an average temperature for the whole
refrigerator. Temperatures inside each area may vary from the temperature
values indicated on the display, depending on how much food you store and
where you place them. Ambient temperature may also affect the actual
temperature inside the appliance. When you set the temperature of both the
fridge and freezer these aspects should be taken into account
The S M
MART ODE
the first time (s. chapter 4.6 S
The temperatures of both the fridge and freezer can be changed manually as
needed.
The operating buttons of the display will be locked automatically after each
operation. Before you can carry out further settings of the temperatures or
modes you always have to press the unlock button (D) for 3 seconds to unlock
the operating buttons.
To perform the following settings the display must be unlocked.
T
 The adjustable temperature range is from +8
1. If the operating buttons are locked
button (D) for 3 seconds. The operational status indicator of the
key lock (8) goes off. The operating buttons are unlocked.
2. For the selection of the compartment (fridge / freezer) press the
button "R " (A) repeatedly until the indicator of the
OOM
temperature of the
Depending on model
16
is the default setting
ELECTION OF THE MODES
EMPERATURE SETTING OF THE FRIDGE
(1) flashes.
FRIDGE
" (A) for the selection
OOM
EMPERATURE
PERATING BUTTONS AND DISPLAY
16 , when you operate the appliance for
/ S
MART MODE
:
0 C to +2 0 C.
(8), press the unlock
" (C) for the
).
).
61