Additional Safety Rules - Panasonic EY3610 Bedienungsanleitung

Original instructions: English
Translation of the original instructions:
Other languages
I. INTENDED USE
Thank you for purchasing the Panasonic
Sealing Gun. This Sealing Gun is for
pushing the sealing compounds. Sausage
type and cartridge type are applicable for
this model. The speed can be adjusted
according to work.
II. ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not
have to be plugged into an electrical
outlet.
2) Stop using the tool if you notice
something abnormal.
3) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
4) The appliance is not intended for use by
young children or infi rm persons without
supervision.
5) Young children should be supervised
to ensure that they do not play with the
appliance.
WARNING:
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use
of the recycled battery pack and the
counterfeit battery pack.
• Do not dispose of the battery pack in a
fi re, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks,
dismantle it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
EY3610_EU.indb 6 EY3610_EU.indb 6
• Do not charge the battery pack in a
high-temperature location, such as next
to a fi re or in direct sunlight. Otherwise,
the battery may overheat, catch fi re, or
explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fi re.
• When the battery pack has deteriorated,
replace it with a new one.
Continued use of a damaged battery
pack may result in heat generation,
ignition or battery rupture.
Preparing the sealing gun
1) Cut off the tip of the cartridge. The
smaller the opening, the more pressure
is required to squeeze out the sealing
compound; consumption of battery
power rises accordingly.
Cut the opening to the desired diameter
(a minimum of 3 mm). (Fig. 1)
2) Punch a hole in the aluminum seal of the
cartridge. If you forget to perforate this
seal, the sealing compound may come
out of the rear part of the cartridge,
damaging and soiling the sealing gun.
(Fig. 2)
If a previously opened cartridge is to
be used again, remove the hardened
material with a needle or another pointed
tool. (Fig. 3)
6
2012/07/20 14:22:55 2012/07/20 14:22:55