Controls And Their Functions; Front Panel - Yamaha YST-SW015 Bedienungsanleitung

CONTROLS AND THEIR FUNCTIONS

Port
6
110V – 120V 220V – 240V
VOLTAGE
SELECTOR
POWER
ON
OFF
7
1
Power indicator
Lights up in green while the subwoofer is on.
Lights up in red while the subwoofer is set in the
standby mode by the operation of the automatic power-
switching function.
Goes off when the subwoofer is set in the standby
mode.
2
STANDBY/ON button
Press this button to turn on the power when the
7
POWER ( ) switch is set in the ON position. (The
power indicator lights up in green.)
Press again to set the subwoofer in the standby mode.
(The power indicator goes off.)
Standby mode
The subwoofer is still using a small amount of power
in this mode.
3
B.A.S.S. (Bass Action Selector System) button
When this button is pressed in to the MUSIC position,
the bass sound in audio software is well reproduced.
By pressing the button again so that it pops out at the
MOVIE position, the bass sound in video software is
well reproduced.
MOVIE

Front panel

SUBWOOFER SYSTEM YST-SW015
STANDBY/ON B.A.S.S. HIGH CUT 50–150Hz VOLUME 0–10
Rear panel (General model)
INPUT
AUTO PHASE
/MONO
STANDBY
OFF LOW HIGH NORM REV
110V–120V 220V–240V
VOLTAGE
SELECTOR
POWER
ON
OFF
MUSIC
SUBWOOFER SYSTEM YST-SW015
STANDBY/ON B.A.S.S.
1 2 3
INPUT
/MONO
STANDBY
OFF LOW HIGH
8
4
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
90 Hz
80 Hz
70 Hz
60 Hz
50 Hz
5
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
6
VOLTAGE SELECTOR switch
(For China, Korean and General models)
If the preset setting of the switch is incorrect, set the
switch to the proper voltage range (220V-240V or
110V-120V) of your area.
Consult your dealer if you are unsure of the correct
setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
HIGH CUT 50 – 150Hz VOLUME 0 – 10
4 5
AUTO PHASE
NORM REV
9 0
100 Hz
110 Hz
120 Hz
130 Hz
140 Hz
150 Hz
5
E-