Controls And Their Functions - Yamaha YST-SW225 Bedienungsanleitung

CONTROLS AND THEIR FUNCTIONS

1
Front panel
AUTO
STANDBY
HI G H
LOW
OFF
TO SPEAKERS
FROM AMPLIFIER
VOLTAGE
SELECTOR
220V-240V
110V-120V
e
Rear panel
(General model)
1 Power indicator
Lights up in green while the subwoofer is on.
Lights up in red while the subwoofer is set in the
standby mode by the operation of the automatic power-
switching function.
Goes off when the subwoofer is set in the standby
mode.
2 STANDBY/ON button
Press this button to turn on the power when the
POWER switch is set in the ON position. (The power
indicator lights up in green.)
Press again to set the subwoofer in the standby mode.
(The power indicator goes off.)
Standby mode
The subwoofer is still using a small amount of
power in this mode.
8
AUTO
STANDBY
HI G H
LOW
OFF
OUTPUT INPUT PHASE
2
L /MONO
NORM REV
R
INPUT 1
VOLTAGE
SELECTOR
220V-240V POWER
ON
110V-120V
POWER
OFF
OFF
7
Advanced
2
9
OUTPUT INPUT
2
TO SPEAKERS
L
/MONO
R
INPUT 1
FROM AMPLIFIER
0 q
ON
3 B.A.S.S. (Bass Action Selector System) button
When this button is pressed in to the MUSIC position,
the bass sound in audio software is well reproduced.
By pressing the button again so that it pops out at the
MOVIE position, the bass sound in video software is
well reproduced.
4 HIGH CUT FILTER button
Set this button to ON to stop the output of signals
above the frequency set using the HIGH CUT control.
Set to PASS to output all signals regardless of the
HIGH CUT control setting.
3 4 5
Control panel
PHASE
NORM REV
w
PASS ON
6
9