Controls And Their Functions; Front Panel; Rear Panel - Yamaha YST-SW800 Bedienungsanleitung

CONTROLS AND THEIR FUNCTIONS

POWER
ON
OFF
5
1
Power indicator
Lights up while the subwoofer is turned on.
2
STANDBY/ON button
Press this button to turn on the power. Press again to
set the subwoofer in the standby mode.
* This button can be used only when the POWER (
switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
3
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
80Hz
70Hz
60Hz
50Hz
8
E-

Front panel

SUPERWOOFER SYSTEM YST–SW800
STANDBY/ON HIGH CUT 40–140Hz VOLUME 0–10

Rear panel

BASS PHASE AUTO OUTPUT
STANDBY /MONO TO SPEAKERS
MUSIC MOVIE REV NORM HIGH OFF
LOW
FROM AMPLIFIER
INPUT INPUT
2 1
POWER
ON
OFF
90Hz
100Hz
110Hz
120Hz
130Hz
40Hz 140Hz
STANDBY/ON HIGH CUT
1 2
6 7 8
BASS PHASE
STANDBY
MUSIC MOVIE REV NORM HIGH
4
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
5
POWER switch
5
Normally, set this switch to the ON position to use the
)
subwoofer. In this state, you can turn on the subwoofer
or turn the subwoofer into the standby mode by
pressing the STANDBY/ON (
switch to the OFF position to completely cut off the
subwoofer's power supply from the AC line.
6
BASS switch
By setting this switch to the MOVIE position, the bass
sound in video software is faithfully reproduced. By
setting it to the MUSIC position, the bass sound in
audio software is well reproduced.
VOLUME
40 – 140Hz 0 – 10
3 4
9 0
AUTO OUTPUT
/MONO
TO SPEAKERS
OFF
LOW
FROM AMPLIFIER
INPUT INPUT
2
A
2
) button. Set this
1