Controls And Their Functions; Front Panel; Rear Panel - Yamaha YST-SW205 Bedienungsanleitung

CONTROLS AND THEIR FUNCTIONS

OUTPUT
TO SPEAKERS
+ –
+ –
FROM AMPLIFIER
INPUT
1
~
Power indicator
Lights up in green while the subwoofer is turned on.
Ÿ
STANDBY/ON button
Press this button to turn on the power. (The power
indicator lights up in green.)
Press again to set the subwoofer in the standby mode.
(The power indicator does not light.)
* This button can be used only when the POWER (
switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
!
B.A.S.S. (Bass Action Selector System) button
When this button is pressed in to the MUSIC position,
the bass sound in audio software is well reproduced.
By pressing the button again so that it pops out at the
MOVIE position, the bass sound in video software is
well reproduced.
MOVIE
8
E-
STANDBY/ B.A.S.S. HIGH CUT
ON
MOVIE
MUSIC
40Hz 140Hz
INPUT AUTO
2 STANDBY
– +
/MONO
– +
OFF
LOW
MUSIC

Front panel

VOLUME
0 10
PHASE
HIGH
NORM REV

Rear panel

⁄
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
%
)
@
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
SUPERWOOFER SYSTEM YST-SW205
STANDBY/ B.A.S.S. HIGH CUT VOLUME
ON MOVIE
MUSIC
40Hz 140Hz 0 10
OUTPUT INPUT AUTO PHASE
2 STANDBY
TO SPEAKERS
+ – – +
/MONO
+ – – +
OFF HIGH
LOW NORM REV
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
VOLTAGE
SELECTOR
*Illustration shows YST-SW205.
HIGH CUT
40Hz 140Hz
POWER
ON
OFF
VOLTAGE
SELECTOR