Appliance Installation; Removing The Appliance; Power Supply; Troubleshooting - STIEBEL ELTRON CNS 50 S Bedienung Und Installation

INSTALLATIoN

Troubleshooting

9.3

Appliance installation

f Hook the appliance by its slots in the back of the appliance on f
to all four tabs of the wall mounting bracket simultaneously.
f Push the appliance to latch it in position. f
1 Locking bolt
2 Wall mounting bracket
f Turn the locking bolt in the wall mounting bracket fully clock- f
wise; this locks the appliance in place.
1
1 Appliance
2 Safety cap
3 Locking bolt
f Push the safety cap onto the locking bolt to prevent it from f
loosening.
9.4

Removing the appliance

1
1 Appliance
2 Safety cap
3 Locking bolt
f Remove the safety cap from the locking bolt. f
f Undo the locking bolt on the wall mounting bracket. f
f Lift the appliance up slightly and pull it forwards and away f
from the wall mounting bracket.
www.stiebel-eltron.com
9.5
f Ensure the on-site supply cable has an adequate
f When connecting the appliance via a standard socket, ensure
1
2
10. Troubleshooting
2
The power cable must only be replaced by a contractor using our
original spare parts.
3

11. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety instructions. Hand over the operating and
installation instructions to the user.
2
3

Power supply

f
cross-section.
f
that the socket is easily accessible once the appliance has
been installed.
WARNING Electrocution
- Carry out all electrical connection and installation
work in accordance with relevant regulations.
- Ensure the appliance can be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
- Do not install the appliance with a fixed power
cable.
Note
Observe the type plate. The specified voltage must match
the mains voltage.
CNS S | CNS U | 17