Bosch Drive Unit Benutzerhandbuch Seite 20

English–7
– "International": You can set speed and distance in kilo-
metres or miles, display clock in 12 or 24 hour format, se-
lect the time zone and set your preferred language. The
current time is automatically taken from the GPS signal.
– "Map&Navigation": Here you can configure the map dis-
play and turn on automatic adaptation of the display, de-
pendant on the ambient brightness.
– "Brightness": You can adjust the brightness of the display
here.
– "My Nyon": Here you can create a new user profile, config-
ure the Home button, the counters, such as journey dis-
tance, calories burned and automatically set average val-
ues to 0 every night or reset Nyon to the factory
configurations.
Status display
Depending on the operating mode shown, all status indica-
tors are not always displayed.
s1 s2
14:30
s5 s6 s7 s8
s1 Bike lights display/Charge level indicator of Nyon battery
pack
s2 Clock display
s3 Speed display
s4 North display
s5 Bluetooth®/WiFi connection display
s6 Assistance level display
s7 Charge level indicator of the eBike battery pack
s8 GPS signal display
s9 Zoom range/remaining range display
0 276 001 SPN | (17.7.14)
Energy supply of the on-board computer
If the on-board computer is in the holder 4, a sufficiently
charged eBike battery pack is inserted into the eBike and the
eBike system is turned on, then the Nyon battery pack is pow-
ered by the eBike battery pack.
If the on-board computer is removed from the holder 4, the
energy is supplied via the Nyon battery pack. If the Nyon bat-
tery pack is weak, a warning message appears on the display.
To charge the Nyon battery pack, insert the on-board comput-
er back into the holder 4. Note that if you do not charge the
eBike battery pack straight away, the eBike system will auto-
matically switch off after 10 minutes of inactivity. In this case,
the charging of the Nyon battery pack will also cease.
You can also charge the on-board computer via the USB port.
Open the protective cap 9. Connect the USB port 8 of the on-
board computer via a micro USB cable with a standard USB
charger (not included in the delivery) or the USB port of a
computer (5 V charging voltage, max 500 mA charging cur-
rent.).
Note: If Nyon is shut down during charging, Nyon can only be
switched on again if the USB cable has been disconnected.
If the on-board computer is removed from the holder 4, all val-
ues of the features are saved and can still be displayed.
Without recharging the Nyon battery pack, date and time will
remain up to a maximum of 6 months. When switching back
s3 s4
on, date and time are reset after a successful GPS fix.
Note: To achieve a maximum lifespan of the Nyon battery
pack, the Nyon battery pack should be recharged every
22
km/h
6 months.
Switching on/shutting down the on-board computer
To switch on the on-board computer briefly press the On/Off
button 5.
To shut down the on-board computer press the On/Off but-
ton 5 for at least 1 second.
100 m
If no button is pressed after 5 minutes, Nyon goes into power
saving mode (back lighting off) and shuts down automatically
after a further 5 minutes.
s9
Nyon reset
105 km
If, contrary to expectations, Nyon can no longer be operated,
then Nylon can be reset by simultaneously pressing the but-
tons 1, 2, 5 and 6. Carry out the reset only if absolutely nec-
essary, as various configurations may be lost.
Battery Charge-control Indicator
The battery charge level indicator r9 (s7) displays the charge
level of the eBike battery pack. The charge level of the Nyon
battery pack can be read on the display s1. The charge level
of the eBike battery pack can also be read on the LEDs on the
eBike battery pack itself.
Bosch eBike Systems