Bosch Drive Unit Benutzerhandbuch Seite 19

When you switch on Nyon, it begins the satellite search to re-
ceive GPS signals. Once sufficient satellite signal is found, the
operating mode displays "Map&Navigation" of the current
location. In case of unfavourable weather conditions or loca-
tions, the satellite search may take a little longer.
Pressing the joystick 1 to the right allows you to change the
zoom configuration of the map section by selecting the sub
menu on the right side. You can display the range of your
eBike battery pack or choose one from different navigation
options. The zoom configurations for the map section can also
be changed by pressing the joystick.
If you have entered the destination, 3 different routes are
shown, of which you can select one. (Detailed instructions
can be found in the online manual under
"www.Bosch-eBike.com/nyon-manual".)
The selected route will be displayed as shown in the figure
below.
n1
n2
n3
n1 Clock
n2 Map
n3 Zoom level
n4 Compass needle
n5 Turn instructions and distance to the next turn
n6 Distance to destination
n7 Estimated time of arrival at destination
During the navigation, the guidance (e.g. turn left in 50 meters)
will also be displayed via a cross fade in other operating modes.
Navigation within a radius of 20 km of the place of registra-
tion is free of charge. For the release of a larger area, you can
acquire the appropriate licenses via your
"Bosch eBike Connect" smartphone application.
Nylon is not suitable for a navigation without a bicycle (for
hikers or motorists).
At temperatures below 0 °C the altitude measurement may be
faulty.
Operating mode "Fitness"
Via this mode you can view various fitness-related information.
Based on the activity levels provided in your registration, the
effect of your previous activities will be displayed on your
stamina level (training effect).
To check your heart rate, you can use a chest strap, which you
can connect to Nyon via Bluetooth®.
Compatible models can be found in the online manual under
"www.Bosch-eBike.com/nyon-manual".
Bosch eBike Systems
A chest strap is not included in the delivery.
f1
f2
f3
f4
f1 Clock
f2 Current performance/heart rate*
f3 Display of the current training effect
f4 Training effect
f5 Kilocalories burned
f6 Current cadence
f7 Average speed
f8 Maximum speed reached
n4
* When using a chest strap to measure the heart rate (not included
in the delivery), your current heart rate will be displayed instead of
n5
the performance.
Via the sub menus, you can reset the average values or switch
n6
to individualised displays. Detailed instructions can be found
in the online manual under
n7
"www.Bosch-eBike.com/nyon-manual".
Operating mode "Settings"
This operating mode allows you to set the basic configura-
tions of your on-board computer.
Note: Some basic configurations can only be changed when
Nyon is inserted into the holder 4.
To reach the "Settings" menu, press the joystick 1 down in
the main menu until "Settings" is displayed.
Tip: If you press the joystick down long enough, you will also
reach the "Settings" menu.
The following configurations can be made:
– "Connections": You can configure the Bluetooth ® config-
urations, a new smartphone connection, a WiFi connection
or a heart rate monitor.
When you enable WiFi, Nyon searches for available net-
works. Found networks will be displayed. Use the joystick
1 to select the desired network and enter the password.
– "My eBike": When Nyon is plugged in, you can change the
pre-set value given by the manufacturer of the wheel cir-
cumference by ±5 %.
English–6
f5
f6
f7
f8
0 276 001 SPN | (17.7.14)