Resetting To The Factory Setting; Version Information - Bellman & Symfon Audio Domino BE2210 Bedienungsanleitung

Please note that if the tone control is on, the preset value will be changed as
soon as the Tone Control is changed in user mode.

Resetting to the factory setting

8 s
You can use this to reset all settings to the
standard settings that the products were supplied
with from the factory.
Press and hold down the + button (9) until all the
LEDs on the display are lit. After resetting is com-
pleted, the display will blink for a short period.

Version information

The product version information is presented here
via a pattern of lit and blinking LEDs. This internal
information is only intended as an aid for servicing
and support.
320
Pairing of units
The Transmitter and Receiver Units in the Bellman Audio Domino system must
have the radio link established in order for radio communication to operate.
To make it easier to get started, a Receiver Unit and a Transmitter Unit which
are paired together are always supplied so that they will work together. Where
you want to pair a Receiver Unit with a Transmitter Unit which is different from
the Receiver Unit it was originally supplied with, you can do this in the Settings
Menu. Proceed as follows to pair up the units:
5 s 5 s
A "running light" on the Receiver Unit's Volume and Tone LED Indicator (8)
moving towards the centre indicates that the link has been established.
Please note! If you pair up a Transmitter Unit and a Receiver Unit in the Set-
tings Menu, this replaces the pairing carried out in the factory. This can be
useful when changing a Transmitter Unit under guarantee or if you want to
pair up several Receiver Units to a Transmitter Unit (e.g. in a conference room).
• Start both the units with the
On/Off buttons i (6, 18).
•
Go into the Settings Menu.
• Hold down the CONNECT
button (19) on the Trans-
mitter Unit.
• Hold down both the M
button (5) and the R but-
ton (7) on the Receiver Unit.
APP
321