Battery Indicator; Establishing A Temporary Link With Another Transmitter Unit - Bellman & Symfon Audio Domino BE2210 Bedienungsanleitung

Battery indicator

The Battery Status LED (3, 17) normally lights up green. This indicates that the
unit is switched on and the battery level is satisfactory.
When the battery is low, the Battery Status LED (3, 17) blinks green until the
battery is almost completely flat when it blinks orange instead. As soon as it
blinks green it is time to charge the unit again. If the unit is not charged, it is
switched off automatically.
Charging starts automatically when you connect a charger to the Charging
Socket (14, 21). Charging in progress is indicated on both the charger and
the units by an orange light. Once the battery is fully charged, the indicator
changes to green and the battery is continuously trickle charged until the
charger is disconnected.

Establishing a temporary link with another Transmitter Unit

The radio link between the Transmitter and Receiver Units in the Bellman Audio
Domino must be established in order for radio communication to operate. To
make it easier to get started, Receiver Units and Transmitter Units which are
supplied together are always paired up so that they will work together.
Whenever you want to listen on another Transmitter Unit you can establish a
temporary link with it. As soon as you switch off the Receiver Unit it returns to
working with the paired Transmitter Unit again.
70
Proceed as follows to establish a temporary radio link between a transmitter
and a receiver:
• Start both the units with the On/Off buttons i (6, 18).
• Hold down CONNECT (19) on the Transmitter Unit.
•
Hold down both the M button (5) and the R button (7) on the Receiver Unit.
5 s 5 s
The link can only be established while the Transmitter Unit's connection button
is pressed down - this is for safety reasons to prevent a Receiver from being
able to connect to another Transmitter unobserved.
Please note that it is possible to connect several Receiver Units to the same
Transmitter Unit by repeating the above procedure. There is, however, a risk
that the number of receivers may affect the performance of the system.
DE
DK
A "running light" on the
EN
Receiver Unit's Volume
ES
and Tone LED Indicator (8)
FI
moving towards the centre
indicates that the link has
FR
been established.
IT
JP
NL
PL
SE
SI-CN
TR-CN
APP
71